Maintained! This is a very well made 300B single amp. The outstanding sharpness and power, and sweet and gorgeous sound are unbearable. The JJ 300B is used as the output tube. It is a combination of the popular transformer TAMURA F-2007 pair, PC-3004, and A-4003. The first stage uses 12AT7, and the rectifier tube uses 5AR4. It comes with a volume and can be connected directly to a CD. There is a ham balancer inside (Yasuhito Koshihama)
Maintenance information: 2024.6.5 maintained (AC cord missing added; wiring changed to output impedance 4Ω → 8Ω; main volume 100K B curve → 2 replacement; vacuum tube 12AT7 deterioration replacement; RCA jack and vacuum tube socket caulking repair. Operation checked with AC 100V (measured with rated output 10W+10W SP8Ω)
Accessories: power cable
Main specifications: output 10W+10W (actual measurement) W434 × H217 × D333 mm 18.9 Kg (actual measurement)
Maintained, with remote control! A famous direct drive machine representative of Technics. The torque is high, the start and stop times are extremely short, and the stable operation that immediately enters constant speed is unique. It also drives LP heavyweights without difficulty. There are small scratches and dullness overall (Oikawa Tetsuji)
Maintenance information: 2024.6.4 Maintained (Electrolytic capacitors were replaced due to faulty capacitors in the power supply unit and motor unit)
Accessories: power supply unit, remote control, copy of instruction manual
Main specifications: Direct drive aluminum die-cast turntable 33, 45, 78 rotating body W365 x H100 x D360 mm 9.5 kg power supply unit W110 x H85 x D300 mm 3.8 kg
Maintained! An FM masterpiece arm made in Japan made with a high level of stainless steel and workmanship accuracy. The clear, thick tone that doesn't make you feel incidental sounds is excellent, and the breadth and ease of settings, and the excellent firm and excellent tracing ability in the dynamic balance type are excellent (Oikawa Tetsuji)
Maintenance information: 2024.6.5 Maintained (We will disassemble the arm needle pressure application mechanism part and clean it. The arm lifter skate rubber was replaced due to deterioration. Operation tests with cartridge mounting were also good)
Accessories: phono cable, instruction manual
Main specifications: total length 325 mm effective length 245 mm overhang 15 mm needle pressure application range 0 to 5 g arm height adjustment 25 to 60 mm compatible cartridge weight (including shell) 17 to 44 g mounting hole diameter 31 mm
※Since it is cheap, it will be handed over as is. The design is reminiscent of the Technics SL-1200 series, but I recommend this model for those who want to enjoy functionality and a little bit of fun on their own. It can be used by a wide range of people, from beginners to DJs. The exterior is dull and there are small scratches on the dust cover. Serial C410000041 (Kimiya Yonejima)
Maintenance information: 2024.6.5 operation confirmed
Accessories: instruction manual, power cord, original box
Main specifications: quartz lock brushless servo motor, rotation speed 33, 45, 78 rpm, arm weight 12 g to 17 g (including headshell) size W450 x H157 x D352 mm weight 11.3 kg
It is equipped with a 165 mm diameter woofer that uses a Kevlar woven cone that suppresses the generation of split vibrations, and is equipped with an advanced driver unit that supports rich musicality. The cabinet design is optimized using unique computer software and the latest spectrum analyzer analysis technology, and the input terminals are equipped with 2 sets of speaker terminals compatible with banana plugs. There is a small scratch on the side of the exterior. Serial WH057521BGH0025, WH057521BGH0025 (Fujisawa Yukishi)
Maintenance information: 2024.6.4 operation confirmed
Accessories: instruction manual, original box, jumper plate, saran net
Main specifications: output sound pressure level 87 dB impedance 8 ohms playback frequency band 45 Hz to 20 kHz W196 x H355 x D290 mm weight 6.5 kg
※Since it is cheap, it will be handed over as is. Comes with a remote control. AM/FM stereo tuner with dual-gate MOS FET on the front end. The tone is bright and natural. There are dirt scratches and threads on the exterior. Serial MZ009520050055 (Tamura Eiji)
Maintenance information: 2024.6.5 operation confirmed
Accessories: remote control, instruction manual, AM antenna
Main specifications: AM/FM stereo synthesizer tuner dimensions W428 x H86 x D295 mm weight 3.2 kg
※Since it is cheap, it will be handed over as is. Comes with a remote control! CD-RW compatible CD recorder. This model is equipped with a TEAC high-performance CD/RW drive capable of 4x speed recording. There are small scratches on the exterior. Serial 0240023 (Yonejima Satoshi)
Maintenance information: 2024.6.5 operation confirmed
Accessories: remote control, instruction manual
Main specifications: CD-RW compatible CD recorder, 4x speed recording, finalization, 4x speed microphone, analog output (RCA), 1 system, 2 digital input/output systems each (optical/coaxial), 1 microphone input system, 1 system, W435 x H102 x D312 mm 5.5 kg
Maintained! Macintosh's first power amplifier with a balanced circuit configuration. Resolution and transparency have been added to the traditional rich, extruded tone. The blue meter, which can be said to be synonymous, is alive and well, and has plenty of presence, pleasing not only the ears but also the eyes. The exterior is dull and has small scratches. Serial JGC1730 (Yonejima Satoshi)
Maintenance information: 2024.6.5 Maintained (volume exchange (both channels) due to left channel volume shaft bending and poor contact points) lamp, acrylic removal cleaning due to deterioration of electrolytic capacitors, etc. due to deterioration, solder correction, connector cleaning, panel peeling correction (character area, etc. are not allowed) switch cleaning. Bias and offset check output audio check)
Accessories: copy of instruction manual
Main specifications: 300W+300W (2/4/8Ω), 600W during MONO (2/4/8Ω) W445 x H196 x D420 mm 35 kg
*Although it is a 60 Hz specification, the strobe on the platter is 50 Hz. Maintained! It is a setup that successfully combines the stickiness and guts of the classic Grace arm 545 with few quirks, and the delicate expression with fine grain. It's a car that can be enjoyed regardless of genre. The exterior and flash are not compatible with 50 Hz specifications, and a feeling of use can be seen on the back, such as screw holes, dullness, abrasions, scratches, etc. that seem to be numerous hinge installation marks. Cereal 69774 (Kobayashi Hitoshi)
Maintenance information: 2024.6.5 maintenance completed (motor disassembly/check/lubrication/assembly, motor suspension rubber replacement, suppressor → rebuild replacement, main bearing disassembly/oil filling, oil sealant application, assembly, pulley adjustment, idler cleaning, TT mat replacement, mount rubber washer added, running test OK)
Accessories: none
Main specifications: GRACE G-545: static balance type effective length 237 mm cartridge mounting weight range 9.5 to 34 g (including shell) needle pressure variable range 0 to 5 g GARRARD 301: idler drive compatible with 33, 45, 78 rotations W500 x H210 x D403 mm
Garrard 301 turntable seat. This mat alone changes the sound quality. Try it once! In addition to cracks on the exterior and spindle holes, you can also see a feeling of use such as dullness, abrasions, etc. (Kobayashi Hitoshi)
Accessories: none
2024.4 Maintained! Equipped with Philips CDM4PRO, this player is easy to operate, has plenty of professional features, and excellent durability. It has a higher frequency extension than the A730, and the overall balance from bass to treble is good, and the sound has a solid sense of sound pressure. There is dullness and small scratches all over the exterior (Kobayashi Hitoshi)
Maintenance information: 2024.4.7 Maintained (CD mechanical pickup is movable by checking, dismantling, check assembly → reading OK. All other internal parts of the NG part have been replaced. CD disc plate replacement ~ aging test 6 days ~)
Accessories: power cord, instruction manual (copy)
Main specifications: CDM4PRO mechanical analog output 2 systems (RCA/XLR), 1 digital output system (AES), 1 clock system (BNC) W320 x H131 x D355 mm 6.1 kg
Maintained including pickup replacement (replacement)! A CD player that lets you listen to a glossy, supple sound typical of England. It is the first model in the FMJ series, which continues with the CD36, which aims for a modern approach while retaining the core part of traditional English traditions. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.6.4 maintenance (replacement of products that can be replaced with pickups, mechanical assy cleaning, grease up of various parts) 2024.5.5 operation confirmed
Accessories: remote control, instruction manual, power cord
Main specifications: Equipped with a “24 bit ring DAC” jointly developed with DCS, HDCD compatible digital output: coaxial/TOS analog output: RCA2 system W430 x H85 x D290 mm 6.5 kg
Speaker for Toshiba's system stereo SL-8 UV. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.6.2 Operation confirmed
Accessories: saran net
Main specifications: W219 x H360 x D167 mm 2.5 kg (actual measurement)
Maintained! A power amplifier from the USA Marantz era. The compact yet powerful American sound is attractive. It works great with speakers that make a lot of noise, such as JBL, and you can enjoy an exciting sound that is clear. Exterior, paint deterioration, dullness, abrasions, etc. can be seen (Kobayashi Hitoshi)
Maintenance information: 2024.6.4 maintenance (lamp replacement (replacement), power stage Tr check, C replacement, DC offset, bias adjustment, relay contact cleaning, operation check)
Accessories: none
Main specifications: 80W+80W (8Ω) damping factor 30 (8Ω) power meter (sensitivity can be switched in 3 levels) mounted dimensions W358 x H120 x D273 mm weight 11 kg
Currently sold. This is a self-made 10cm full-range 1-way speaker with unknown details. There is no problem with the sweep or music signal, but the current situation is because it is cheap. There are bond marks on the exterior and center cap, and a feeling of use can be seen, such as dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.6.3 sound output confirmed
Accessories: none
Main specifications: W120 x H200 x D122 mm 2.5 kg (actual measurement)