A speaker equipped with a DENON16RW04 and PIONEER PT-10 in a self-made enclosure. It has no habit and it's an orthodox sound. The exterior has scratches and dullness due to use over time (Asaine Tomoho)
Maintenance information: 2024.9.27 sound output confirmed
Accessories: saran net
Main specifications: size W390 x H780 x D270 mm corner placement (275 x 278 mm) weight 10.4 kg (actual measurement)
The details of the self-made speakers and units are unknown. With a relaxed sound centered around the mid to low frequencies,
The enclosure is relatively carefully made. The exterior has a feeling of wear over time, such as scratches and dullness (Asaine Tomoho)
Maintenance information: 2024.9.27 sound output confirmed
Accessories: saran net
Main specifications: size 250 x 695 x 300 mm, weight 8.5 kg (actual measurement)
The price has been reduced. 2024/9/18 sales price 99,800 yen for 1 bottle only. Since corn paper has tear repair marks, it is inexpensive. It is a self-made enclosure system with a 604D green unit. The volume ratio between the unit and enclosure feels good, and it comes out in the mid to low range. Recommended for those who like mono saxophone and bass recordings. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.9.18 Maintained manufacturer (604D corn paper repair, ATT cleaning)
Accessories: saran net
Main specifications: W647 × H750 × D507 mm kg (actual measurement)
Set of 3 A self-made insulator that imitates “drinking,” which is sometimes used as an insulator. The warm atmosphere is attractive (Daiki Goto)
Accessories: none
Main specifications: Weight approx. 100g
Balance cable An XLR cable with a Neutrik balance plug attached to a 0.13m unknown pair cable. Each pin is connected by 3 thin lines. Details unknown (Murakoshi Yoichi)
Maintenance information: 2024.9.18 continuity confirmed
Accessories: none
A large self-made audio board with a sturdy wooden board sandwiched between a floor mat and felt. It was created by the previous owner for TANNOY Westminster. As for the exterior, there is a feeling of use such as scratches on the bottom (Tamai Jun)
Accessories: none
Main specifications: size W1040 x D700 x H23 mm weight 8.0 kg
Front road horn from unknown manufacturer. The bass reflex on both sides is reminiscent of an Onken enclosure, but details are unknown. There are many bruises on the corner surface. A self-made stand is included, but the casters are damaged (Murakoshi Yoichi)
Accessories: saran net, casters
Main specifications: W600 x H839 x D720mm weight 59.2 kg unit opening W345 (maximum) x H202mm screw pitch 380 mm (length/width) 370 mm (oblique)
The disposal price has been reduced! (Member prices are not applicable) 2022/7/4 sales price 69,800 yen Maintained! The armless TD-125 phono motor is attached to a self-made wooden board instead of a cabinet. There is a feeling of use, stains, and small scratches (Murakoshi Yoichi)
Maintenance information: 2022.6.21 maintenance (main board adhesive jumper line connection, rotation control lamp replacement, stay correction, AC acrylic cover adhesion. Rotation adjustment.) 2022.4.28 Maintenance (Electrolytic Capacitor Replacement, Pitch Volume Contact Cleaning, Rotation Center, Servo Offset Adjustment, Shaft Lubrication, Strobe Mirror Cleaning.)
Accessories: No accessories
Main specifications: belt drive floating mechanism 16, 33, 45 rotation compatible W565 x D542 x H approx. 120 mm
The price has been reduced. 2018/3/3 sales price 10,000 yen Technics horn fixing ring. Recommended for self-made people (Oikawa Tetsuji)
Accessories: none
Main specifications: inner circumference diameter 95mm (actual measurement)
The price has been reduced! 2024/8/9 sales price 10,000 yen This is the woofer part mounted on the Velodyne subwoofer HGS-12. Why don't you build a homemade subwoofer by putting it in a self-made box (Tamura Eiji)
Maintenance information: 2024.8.9 sweep check OK
Accessories: No accessories
The disposal price has been reduced! Member prices are not applicable. 2024/5/2 sales price 10,000 yen with box! This is an 8cm full range unit from MarkAudio's ALPair series. It is a self-made unit that is attracting attention because of its technical ability produced with high accuracy, and advanced playback capabilities, such as precise and delicate high frequencies. (FUJISAWA KOSHI)
Maintenance information: 2024.5.2 operation confirmed
Accessories: original box
Main Specifications: 8cm full range speaker 4Ω 95-30,000 Hz 85.45dB 10W
Disposal price reduction. 2024/3/22 sales price 20,000 yen Self-made enclosure for 38cm units. An ALTEC 416-8C was installed. It is sturdy and heavy. There is a feeling of use on the exterior, such as scratches, paint chips, paint on the back, and screw holes in the top plate. ※Shipping costs will be estimated separately (Mizusaki Ryo)
Accessories: saran net
Main specifications: W660 x H995 x D465 mm (including casters) woofer aperture 360 mm φweight 51.1 kg (actual measurement)
Upholstered sound control panel with unknown details. The size is easy to use. There is a feeling of use such as stains (Daiki Goto)
Accessories: none
Main specifications: W650 x H120 x D650 mm, weight 400 g (actual measurement)
※Inexpensive because it is in poor condition. Self-made 2way/3way enclosure. The size of the hole is different at the top, with an opening diameter of about 315 mm on the top and about 360 mm on the bottom. There are many peeling veneer, corner pads, scratches, etc. (Oikawa Tetsuji)
Accessories: none
Main specifications: W450 x H1056 x D480 mm approx. 33 kg
Self-made enclosure. The previous owner attached a JBL 38cm unit with a 1" driver and used it in 2 ways. It comes with casters. There is a lot of feeling of use, such as uneven paint. Please contact us for shipping (Murakoshi Yoichi)
Accessories: none
Main specifications: W500×H790×D604mm 53.4 kg
A 38cm double configuration enclosure that can be used as a center woofer or center speaker. The previous owner had an electro voice 38cm woofer installed. Comes with casters. There is a lot of feeling of use, such as uneven paint and bolt marks on the top plate. Please contact us for shipping (Murakoshi Yoichi)
Accessories: none
Main specifications: W1045 x H790 x D604 mm 52.2 kg
Inexpensive because it is in poor condition. 38cm enclosure. Originally, the ALTEC 604-8G was included. There are many scratches, cracks and peeling on the decorative plate, and there is screw licking*Shipping is estimated separately (Oikawa Tetsuji)
Main specifications: W660 x H1005 x D465 mm 35.1 kg
A self-made large record player cabinet where Victor's TT-101 was mounted. SAEC's WE-308SX was mounted on the arm. Shipping costs will be estimated separately (Sasaki Shota)
Accessories: none
Main specifications: W630 x H205 x D570 mm, arm hole diameter 43/29 mm, weight 26.2 kg
Self-made cabinet for GARRARD 301 with double arm specifications. The 3012 Series 2 and SMG-212 were mounted on the tone arm installation port. You can see the appearance, peeling veneer, abrasions, bruises, etc., and a feeling of use (Kobayashi Hitoshi)
Accessories: none
Main specifications: W760 x H265 x D520 mm 14.4 kg (actual measurement)
Self-made enclosure. The woofer opening is about 340 mm in diameter, the horn opening above it is 450 mm x 266 mm, the upper opening is 260 mm x 134 mm, and the tweeter part is about 60 mm in diameter. Shipping costs will be estimated separately (Oikawa Tetsuji)
Accessories: none
Main specifications: plate thickness 25 mm W800 x H960 x D580 mm 54.1 kg (actual measurement)
This is a self-made baffle made in a size like JBL VICOUNT or BARON. There is a hole for the 38cm unit to fit, and a hole that is thought to be for a screwdriver. In the screw hole
Accessories: none
Main specifications: woofer section screw pitch 370 mm aperture φ343 mm driver opening 133 mm external dimensions W443 x H518 x D20 mm weight approx. 1.5 kg (one side, actual measurement)
The disposal price has been reduced! Member prices are not applicable. 2022/7/16 selling price 100,000 yen wooden 46cm double woofer type. Baffle opening diameter 425mm Screw pitch 490mm Baffle and enclosure plate thickness 24mm Duct opening diameter 108mm Both the front and back plates cannot be removed. There is a difference in discoloration on the left and right in appearance, and there are corner chips, digging scratches, and dirt stains. (Yutaka Takimoto)
Accessories: none
Main specifications: W1600 × H950 × D850 mm (actual measurement) The weight has not been measured, but it seems that it is 100 kg or more.
The price has been reduced. 2020/4/17 Selling price 5,000 yen Unspecified wooden front baffle. If you are a self-made group, come on. There are scratches and stains scattered, uneven painting, corner chips, etc. (Takasaki Atsushi)
Accessories: none
Main specifications: opening diameter 280 mm bass reflex opening W292 × H80 mm W400 × H610 × D20 mm 1.8 kg/sheet
A self-made record cleaner that imitates PAROSTATIK. The core inside is a vinyl sheet wrapped around it. Thanks to the soft core, it is exquisitely comfortable to use. The exterior has a frayed feeling of use (Katsuji Hiura)
Accessories: none
Main specifications: W105mm diameter 30mm weight 9g
Unspecified 3-way enclosure It is a super bargain price with a considerable feeling of use. For experimentation or research, if you are a self-author with confidence in your arm, how about challenging it? (Yoichi Murakoshi)
Main Specifications: W648 x H967 × D457mm 36.8 Kg (Measurement) Woofer opening diameter 300 mm Scoker opening diameter 173mm tweeter opening diameter 102mm