An enclosure for Yamaha's SR speaker and S1520S incorporating the YST system. The opening for the 38cm woofer+horn is empty. The speaker terminal is 1 Speakon terminal. There is a feeling of commercial use (Murakoshi Yoichi)
Accessories: none
Main specifications: bass reflex floor type W540 x H780 x D438 mm 25 kg (actual measurement)
Disposal prices have been reduced. Member discounts will not be applied. 2023/1/23 sales price 500 yen. Sale as is. 1 YAMAHA full range unit. There is a dent in the center cap, and there is a feeling of use (Kobayashi Hitoshi)
Maintenance information: 2023.1.23 Operation confirmed
Accessories: none
Main specifications: Outer diameter approx. 205 mm, screw pitch approx. 105 mm, weight 1.5 kg
*The attenuator is cheap and is sold as is. This model was measured to improve the quality of the NS-500M. Carbon is used for the woofer. It has a transparent tone typical of Yamaha, has good response, and is made with digital sources in mind. Overall, there is a lot of feeling of use such as small scratches and dullness (Murakoshi Yoichi)
Maintenance information: 2024.6.2 sound output confirmed
Accessories: saran net
Main specifications: 3-way speaker 40Hz-20000Hz 6Ω 100W W374 x H678 x D324.5mm 23.5 kg
Genuine YAMAHA, genuine replacement needle for CG-8100 Operation has not been checked (Murakoshi Yoichi)
Maintenance information: operation unconfirmed
Accessories: original box
There is no problem with the operation, but it will be handed over as is. Yamaha subwoofer. You can easily enjoy powerful sound. The high-cut filter allows you to listen in the desired range, so the range of uses also expands. The exterior has a slightly raised part on the top plate, and there is a scratch on the back corner (Mizusaki Ryo)
Maintenance information: 2024.5.9 sound output confirmed
Accessories: none
Main specifications: A-YST method anti-magnetic amplifier output 250W playback frequency band 20Hz to 160Hz high-cut filter frequency 40Hz to 140Hz continuously variable W340 x H432 x D370 mm 17 kg
*Sound output is OK, but the video hasn't been checked, and since the remote control doesn't work, it's currently being sold. This is a Yamaha advanced AV amplifier released in 2008. Based on the design concept of the highest-grade model, flagship model, and DSP-Z11, it is a highly cost-effective amplifier that is based on a 7.1 channel layout that is easy to handle while also being expandable to 9.1 channels (Kojima Yosuke)
Maintenance information: 2024.6.8 Operation confirmed (sound output confirmed only with analog input (LINE, PHONO))
Accessories: remote control, instruction manual, power cable, sound collection microphone
Main specifications: 7.1 channel compatible, rated output, 140 w/ch HDMI input, 11 RCA inputs (including PHONO1), 1 multi-ch input system (6 ch/8 ch), 5 optical digital inputs, 3 coaxial digital inputs, 18 video systems (D5 x 3, component x 6, composite x 6), 1 dock port, 2 USB ports (USB1.1), Network 1 system (100base-TX/) 10Base-T) W435×H196×D441mm 19.6kg
Internal and external maintenance has been applied and brushed up. The vivid sense of dynamism and the sharpness of the high frequencies typical of YAMAHA have been revived. It has a low frequency thickness that 1000 monitors don't have. It is a timeless masterpiece with a clear sense of transparency, upper and lower driving force, and the smooth connection, and the heavy exterior with an ebony finish that stands out at a glance even today. It is in good condition due to maintenance. Serial 11478L 11478R (Yamato Yuki)
Maintenance information: 2024.4.1 operation confirmed
2023.9.4 Maintained (exterior repair/polishing/clear finish. Rear baffle repair/painting. Saran net replacement. Unit frame painting. Network maintenance (Since the terminals have already been replaced with external products, adjust the direction and tighten, apply a screw fastener, and replace the mounting screws. ATT contact status check (check that there are no gaps). A frequency characteristic measurement check (~ 42 kHz) was performed, and the original capacitor was continuously used because the results were good. Input/output waveform and balance check, sound output check) Unit detachable)
Accessories: saran net
Main specifications: 3-way sealed playback frequency band 40Hz to 20kH sound pressure level 90dB rated input 50W maximum allowable input 100W impedance 8Ω crossover frequency 500Hz/6kHz dimensions W395 x H710 x D349 mm 39 kg
YAMAHA GT racks are highly rigid and have excellent earthquake resistance. The main body is made of 50mm thick particle board, which can firmly support even heavyweight amplifiers. The logo plate is curved, and there is a large repair mark one step below (Oikawa Tetsuji)
Accessories: none
Main specifications: body plate thickness 50 mm medium plate thickness approx. 30 mm W580 x H440 x D440 mm 31.5 kg
The disposal price has been reduced. Member prices are not applicable. 2023/9/11 sale price 10,000 yen rare item! It appears to be a promotional product of YST-SW1000L. The YST-SW1000L can be displayed in a cool way (Oikawa Tetsuji)
Accessories: none
Main specifications: W660 x H20 x D600 mm weight 4.2 kg (actual measurement)
Component cable 10.0m brings out the original high-definition video from a DVD with digital component recording as it is, giving it a sharp black depiction and a sharp three-dimensional effect (Murakoshi Yoichi)
Maintenance information: 2024.6.21 continuity confirmed
Accessories: none
The price has been reduced. 2024/6/22 sales price 40,000 yen XLR female to Fischer cable 0.5m The sound quality is solid and natural, and I have the impression that it makes the most of the original material of the equipment. The appearance is good with little feeling of use (Kobayashi Hitoshi)
Maintenance information: 2024.6.22 continuity confirmed
Accessories: original bag
Speaker cable, 2.2 m pair, Y lug specification, 11 gauge pure OFHC: 99.994% appearance, in addition to the large feeling of use of the Y lug, dullness, threads, and a feeling of use can be seen (Kobayashi Hitoshi)
Maintenance information: 2024.6.21 continuity confirmed
Accessories: none
Speaker cable 2.0m pair 11 gauge pure OFHC: 99.994% exterior, large feeling of use of the Y lug, and dullness, threads, and a feeling of use can be seen (Kobayashi Hitoshi)
Maintenance information: 2024.6.21 continuity confirmed
Accessories: none
Coaxial cable 22.0m unfinished XLO coaxial cable with an unprocessed end. Video, digital, etc. can be used at 75Ω (Murakoshi Yoichi)
Maintenance information: 2024.6.22 continuity confirmed
Accessories: case
※Since it is an old standard, it is inexpensive. HDMI cable 3.0 m gold plate coated terminal uses a flat structure to avoid signal loss, crosstalk, and timing errors caused by uneven length when bent (Murakoshi Yoichi)
Maintenance information: 2024.5.10 sound output confirmed
Accessories: none