In addition to suppressing static electricity and electromagnetic noise by adopting a 0.7 m pair titanium compound sheath, the RCA cable is heat-resistant and can also be used for car audio. It's a bit addictive (Fujisawa Yukishi)
Maintenance information: 2024.5.31 continuity confirmed
Accessories: No accessories
Speaker cable 3.0 m/4.3 m pair end end uses a μ-conductor with unique processing applied to the PC-OCC conductor for the purpose of reproducing sound with good sharpness, and it is a cable with excellent cost performance that also achieves delicate high-frequency reproduction (Fujisawa Yukishi)
Maintenance information: 2024.5.31 continuity confirmed
Accessories: No accessories
※6 month warranty. It is a speaker that was made for natural sound and gained popularity. There is no sense of emphasis and there is a good balance of strength between the high and low frequencies, which have a high texture, and it makes me feel the high level of musicality. There are scratches on the exterior. Serial 16400837L, 16400837R (Fujisawa Yukishi)
Maintenance information: 2024.5.31 operation confirmed
Accessories: jumper cable
Main specifications: 2-way, 2-speaker sealed, magnetic-proof type, W270 x H456 x D290 mm, 12.5 kg
Maintained! Second generation model of the famous P-300 series. The sharp, sharp, and exhilarating sound is alive and well. It also goes well with JBL, etc., and makes a powerful sound. You can enjoy rough sounds that cannot be experienced with current products. There are scratches and scratches on the exterior. Serial B8Y695 (Fujisawa Yukishi)
Maintenance information: 2024.5.31 Maintained (output relays, film capacitors, electrolytic capacitors, semi-fixed VR, etc. replaced. Fixed due to fixed switch. ATT disassembly and cleaning. SP switch polishing cleaning. Solder correction. Card edge contact cleaning. Increase and tighten the output terminals. ※Bias and offset check adjustment. Output audio check. (*When using MAIN & REMOTE1 speakers, be sure to connect both speakers.)
Accessories: power cord
Main specifications: 150W+150W (8Ω) W445×H160×D355mm 25kg
Denon's current CD player. Made in 2023 It is equipped with AL32 Processing Plus, which upsamples 44.1 kHz/16 bit data to 705.6 kHz/32 bit during CD playback and performs bit expansion processing. It comes with a front USB input that supports DSD high-resolution file playback. It is in good condition with no noticeable scratches. Serial DBTG082303357 (Fujisawa Yukishi)
Maintenance information: 2024.5.31 operation confirmed
Accessories: remote control, instruction manual, power cord, RCA cable, original box
Main specifications: output RCA, digital coaxial, 1 optical system each W434 x H107 x D328 mm 4.9 kg
This is the 3rd generation model of the 500 series with the familiar clean power supply. It secures and supplies clean power that is free from dirty electricity mixed into the home. Now in the 3rd generation, it is an excellent item where progress can be seen not only in the transparency of the mid to high range, but also in the sense of energy in the low range. As for the exterior, there are line marks on the back. Serial D2Y023 (Fujisawa Yukishi)
Maintenance information: 2024.5.31 operation confirmed
Accessories: instruction manual, power cord, original box
Main specifications: rated output capacity 510VA, rated output voltage AC100V±1V output outlet, 3P x 8 meters/input/output voltages, strain rate, etc. Switch between 6 types and display W465 x H181 x D386 mm 23.8 kg
The next generation model of the L-550AX has been reviewed and refined from basic performance. We have introduced the latest technology comparable to the higher-level model L-590AX2, such as the unique ODNF 4.0 amplification feedback circuit, the new LECUA 1000, and a buffer circuit with a discrete configuration. It is a practical modern machine with enhanced resolution while acquiring the glossy and dense sound unique to pure A class amplification systems. There are no noticeable scratches on the exterior. Serial G60800238 (Fujisawa Yukishi)
Maintenance information: 2024.5.31 operation confirmed
Accessories: remote control, instruction manual, power cord
Main specifications: rated output 20W+20W (8Ω) 40W+40W (4Ω) W440 × H178 × D454 mm 24.3 kg
Maintenance has been completed, such as creating a new dust cover and replacing capacitors! Micro belt drive middle class player. Coupled with a 3.2 kg heavyweight platter, the tone is extremely quiet and smooth. The cabinet is also highly rigid, leading to thick, stable analog sound. There are dullness and small scratches on the exterior. Serial 49120206 (Yonejima Satoshi)
Maintenance information: 2024.6.1 Maintained (new dust cover created. Motor bearing oil replacement, replacement of deteriorated parts (electrolytic capacitors, semi-fixed resistors, rectifier diodes). Tone arm disassembly/bearing replacement. Lifter disassembly/grease up Speed switching SW, fine rotation adjustment, volume disassembly/contact polishing. Check turntable rotation speed, check arm operation, and needle pressure. Exterior cleaning, sound test, and other operation checks)
Accessories: No accessories
Main specifications: belt drive type static balance type tone arm needle pressure variable range 0 g to 3 g compatible cartridge dead weight 11.5 g to 21 g (including shell) W510 x H155 x D400 mm 13 kg
Maintained! This is a JBL mid to high range driver. It is also used in the S2600 and S3500, etc., and the well-balanced sound quality with both strength and subtlety is truly a JBL. It can be used on various systems with easy-to-use specs. The exterior has peeling paint, dullness, etc. Serial 041250 041277 (Yonejima Satoshi)
Maintenance information: 2024.6.1 maintained (diaphragm installation adjustment, pad dampener and screw connections OK. DCR (041250/3,4ohm diaphragm no scratch) DCR (041277/3,0ohm diaphragm no scratch))
Accessories: No accessories
Main Specifications: High Range Driver Throttle Diameter 25mm Impedance 8Ω Frequency Range 500Hz to 20kHz Pure Titanium Crossover Frequency 800Hz W147 x H147 x D105 mm 4.3 kg
Maintained! The classic model for professional 1" screwdrivers. It is installed in many of the company's 43 series, etc., and it is a driver that is easy to balance with various woofers and tweeters. The exterior has dullness and small scratches. There are some scratches on the diaphragm on one side. Serial 60878/74750 (Yonejima Satoshi)
Maintenance information: 2024.6.1 Maintained (diaphragm installation adjustment, pad dampener installation, screw rust replacement. Wiring terminal contact cleaning, terminal dirt cleaning. Insulating bushing replacement. Diaphragm dirt cleaning. DCR (29324/6Ω diaphragm undamaged) DCR (33387/5.8Ω diaphragm damaged)
Accessories: No accessories
Main specifications: 1 inch driver, throat diameter: 25 mm, 16 ohms, 118 dB, frequency characteristics: 800 Hz to 20 kHz, crossover frequency: 500 Hz or more, 5.1 kg
A center speaker that develops ELAC's new-generation quality into multi-channel. It can easily handle the latest multi-channel sources that require huge amounts of information from the center channel. The exterior has line scratches on the TW periphery and threads on the top plate. Serial 0614 (Yonejima Satoshi)
Maintenance information: 2024.6.1 sweep check is good
Accessories: saran net
Main specifications: center speaker, 2.5-way bass reflex, efficiency 89dB, impedance, 4Ω, frequency characteristics, 32 to 50,000 Hz, crossover frequency, 450/2,400 Hz, maximum input 160 W, W650 x H204 x D314 mm, weight 14 kg
*Lead wire missing. Popular wood headshell Asada cherry blossoms from Hokkaido are used as the material, and it is a hard, good-sounding material that is also used for speakers and headphone cases (Tamura Eiji)
Maintenance information: 2024.6.1 operation confirmed
Accessories: No accessories
Main specifications: Hokkaido Asada cherry heartwood self-weight 10.4 g
Comes with original box Oyaide high quality power plug. The dual monocoque housing made of POM and aluminum has outstanding mechanical strength, and also boasts excellent vibration damping characteristics and noise resistance. Then, beryllium copper was newly adopted for the electrode part, and two-layer platinum+palladium plating, which was determined repeatedly through thorough audition tests, was used for plating (Tamura Eiji)
Accessories: instruction manual, original box
Main specifications: Suitable for cables, outer diameter minimum 6.5 mm maximum 17 mm
For the first time in about 8 years, Mysonic Labs ultra-low impedance mono MC cartridges have arrived! It is a cartridge designed to extract as much information as possible from mono LPs. Even though it's clear, you can feel the richness of the relaxed sound, and it makes me reaffirm the goodness of mono LPs. Serial A577 (Tamura Eiji)
Maintenance information: 2024.6.1 operation confirmed
Accessories: instruction manual, original box, needle cover, brush
Main specifications: Ultra low impedance MC cartridge frequency range 10 Hz to 50 kHz output voltage 0.4 mV impedance 1.2 Ω needle pressure 3 g