Dividing network with a crossover frequency of 1.2 kHz ideal for 2-way horn systems. In addition to an attenuator for high frequency adjustment, it is also equipped with an HF boost switch, so it is possible to adjust the sound to the optimal sound when using a bi-radial horn when using PA. The exterior has dullness and small scratches. (YONEJIMA Satoshi)
Maintenance information: 2020.11.8 Maintenance completed (the lug plate is broken at the attachment part of the internal wiring, repaired with bare terminals (carried out on both left and right). Reinforce the coil with silicone so that the attachment does not slip. Terminal rust removal, acid washing treatment, polishing, cleaning, insulation bush & mounting screw replacement ATT (SW type) contact cleaning. Frequency characteristic measurement checks (~ approx. 42 kHz) were performed, and the results were good, so the original capacitor was continuously used. (Input/output waveform and balance check, sound output check)
Accessories: no accessories
Main Specifications: Crossover 1200 Hz impedance low range 8 ohm/high range 16 ohm high frequency attenuation 6/8/10 dB switch
Maintained! A frequently used crossover 800Hz network. Although it has an impedance specification of 8 ohms, it is an excellent product that can match 375 (16 ohms) without changing the characteristics due to the correction circuit. The exterior is dark and has small scratches (Wang Exhibition)
Maintenance information: 2019.1.4 Maintained (terminal rust removal, cleaning. Insulating bush mounting screw replacement. ATT exchange. Frequency characteristics were measured and checked, and the original capacitor was continuously used for good results. (Check input/output waveform and balance, check sound output)
Accessories: none
Main specifications: allowable input 100W 8Ω body size W121 x H152 x D75 mm case size W175 x H90 x D225 mm approx. 2.7 kg
The deteriorated capacitors have been replaced with DAYTON film capacitors! The grain of the sound is clear and the smoothness of the connection has also been improved. crossover 1200 Hz. This network is ideal for the combination of a 38cm woofer and a 1-inch driver. The exterior has stains, paint peeling, etc. (Wang Zhan)
Maintenance information: 2015.10.22 Maintained (terminal polishing, cleaning, insulation bush, mounting screw replacement. ATT cleaning. Exterior cleaning. Check the input/output waveform and balance, and check the sound output. Frequency characteristic measurement check. (*2013.1.28 capacitors have been replaced)
Accessories: none
Key Specifications: Crossover 1200 Hz 8 Ohm 3 Position Switch with Level Control 1.8 kg
2023.12.18Maintained professional cross 800Hz network. It is used in the 4320, etc., and the low frequencies are pushed out smoothly, giving the impression that the clarity of the mid-high range has improved. This network is useful for creating 2-way systems where woofers have a certain amount of area. How about making a 2-way horn system with a 16Ω unit? There are stains and rust on the main body. (TERAMOTO Hidehiko)
Maintenance information: 2023.12.18 Maintained (terminal rust removal treatment, cleaning, mounting screw replacement. SW type ATT contact cleaning. Frequency characteristics are measured and checked, and the original capacitors are continuously used for good results. (Check the input/output waveform and balance, check the sound output)
Main specifications: crossover frequency 800 Hz impedance 12 to 16 ohms W122 x H154 x D132 mm 1.9 kg/1 unit