The disposal price has been reduced! (Member discounts are not applicable) 2024/3/7 sales price 398,000 yen Exterior maintenance completed! Replace network capacitors with SOLEN film capacitors. The unit is DENTECH Tune HDP385, and the enclosure is made by Shinkosha. The unit is attached by removing the back plate, and the net does not come off the front. Classical music also goes well with symphonies. The exterior is generally beautifully finished due to maintenance. Serial AYT71012 AYT71012 (Tomonori Asaine)
Maintenance information: 2024.3.7 Maintained (exterior repair/cleaning
Rear baffle paint saran net replacement unit maintenance (exterior cleaning, low range center adjustment, screw tightening, high frequency magnetic circuit slit cleaning/center adjustment) ATT cleaning/knob adjustment unit detachment)
2015.5.14 Maintained (network capacitors replaced with SOLEN. Unit edge replacement. Magnetic circuit overhaul and operation adjustment. Saran net partial cleaning net tear repair, complementary color correction)
Accessories: none
Main specifications: used unit HPD385 frequency characteristics 20Hz to 20kHz allowable input 85W 92dB 8Ω W600 x H1075 x D380 mm approx. 42 kg/bottle
Maintained. Genuine Electri 100V specification. Macintosh's classic preamp. It reproduces bright, glossy tones with clear mid-range sounds. This model should be used by music fans who enjoy all kinds of sources. The fact that it has a full range of functions, such as a 5-band equalizer and a 7-source input selector, is also attractive. There is a line wound on the top plate (Oikawa Tetsuji)
Maintenance information: 2024.5.14 maintained (each SW, VOL cleaning, push button dismantling and cleaning, companion pot failure → replacement, lamp deterioration → replacement, panel peeling correction (text part is not possible), operation check (the gap cannot be completely removed)
Accessories: copy of instruction manual
Main specifications: Equalizer up and down 12dB (center frequency/30Hz/150Hz/500Hz/1.5kHz/10kHz) rated output 20W+20W (8Ω) W445 x H192 x D395 mm 11.8 kg
The disposal price has been reduced. Member prices are not applicable. 2024/5/20 sales price 198,000 yen Kappa series improved model Renaissance 90. The mid-high range is composed of EMIM and EMIT special units, and the sound is extremely delicate and clear. The deep sound field space and glossy, moisturized mid to high frequencies are unique to ribbon units. It has high resolution throughout the entire range and is suitable for classical and vocal styles. There are small scratches and line wounds, and there are repair marks of broken decorative plates at the foot (Oikawa Tetsuji)
Maintenance information: 2013.12.15 Maintained (exterior repair and cleaning. (Back side urethane deteriorated, replaced with substitute urethane)
Accessories: spikes
Main specifications: 4 way 4 speakers sealed floor type EMIT tweeter EMIM mid-range ribbon type 87dB 4Ω 250W W435 x H1245 x D315 mm 35.8 kg
Maintained! A classic British Quad stereo power amplifier. Small in size yet full torque. The sound, which is as deep as a tube amp, exudes an appeal that won't fade. The exterior has a feeling of use over time, such as dullness and small scratches. Serial 62226 (Yonejima Satoshi)
Maintenance Information: 2024.3.25 Maintained (INPUT DIN 4P replacement, internal Tr, C, R all checks. DIN4P-RCA female cable created. Operation check, pattern solder processing)
Accessories: power cable, connection cable
Main specifications: 45W+45W W120×H159×D324mm 8.2 kg
The price has been reduced! 2024/5/18 sales price 79,800 yen Maintained! The classic model for professional 1" screwdrivers. It is installed in many of the company's 43 series, etc., and it is a driver that is easy to balance with various woofers and tweeters. The exterior has dullness and small scratches. Serial 60878/74750 (Tamura Eiji)
Maintenance information: 2024.5.18 Maintained (diaphragm installation adjustment. Pad dampener, mounting screw rust replacement. Wiring terminal contact part cleaning, terminal dirt cleaning, insulation bushing replacement. Diaphragm dirt cleaning, internal wiring cable replacement. DCR (74750/6Ω diaphragm no scratch) DCR (60878/5.7Ω diaphragm no scratch))
Accessories: No accessories
Main specifications: 1 inch driver, throat diameter: 25 mm, 16 ohms, 118 dB, frequency characteristics: 800 Hz to 20 kHz, crossover frequency: 500 Hz or more, 5.1 kg
The price has been reduced! 2024/5/25 sales price 79,800 yen Maintained! The classic model for professional 1" screwdrivers. It is installed in many of the company's 43 series, etc., and it is a driver that is easy to balance with various woofers and tweeters. The exterior has rust and paint peeling due to aging. ※The diaphragm is DR16R2421. (YONEJIMA Satoshi)
Maintenance information: 2024.5.25 Maintained (diaphragm installation adjustment, pad dampener, mounting screw rust replacement. Material terminal contact part cleaning, terminal dirt cleaning, insulation bushing replacement. Diaphragm dirt cleaning. This is a genuine diaphragm, but it comes with DR16R2421. DCR (A/7.1 ohm diaphragm scratch) DCR (b/6.3 ohm diaphragm scratch))
Accessories: No accessories
Main specifications: 1 inch driver, throat diameter: 25 mm, 16 ohms, 118 dB, frequency characteristics: 800 Hz to 20 kHz, crossover frequency: 500 Hz or more, 5.1 kg/piece
The price has been reduced! 2024/6/1 sales price 69,800 yen Maintained! The classic model for professional 1" screwdrivers. It is installed in many of the company's 43 series, etc., and it is a driver that is easy to balance with various woofers and tweeters. The exterior has dullness and small scratches. There are some scratches on the diaphragm on one side. Serial 60878/74750 (Yonejima Satoshi)
Maintenance information: 2024.6.1 Maintained (diaphragm installation adjustment, pad dampener installation, screw rust replacement. Wiring terminal contact cleaning, terminal dirt cleaning. Insulating bushing replacement. Diaphragm dirt cleaning. DCR (29324/6Ω diaphragm undamaged) DCR (33387/5.8Ω diaphragm damaged)
Accessories: No accessories
Main specifications: 1 inch driver, throat diameter: 25 mm, 16 ohms, 118 dB, frequency characteristics: 800 Hz to 20 kHz, crossover frequency: 500 Hz or more, 5.1 kg
Maintained! A late model in the classic 607 series. It has high-resolution, well-defined sound, and is compatible with modern speakers. You can experience SANSUI's ability. There are threads and small scratches (Daiki Goto)
Maintenance information: 2024.6.2 maintained (maintenance contents/TONE and other subsonic, loudness, processor, muting, source direct, power amplifier direct, input selector, tape switch disassembly, polishing grease application, output relay replacement, protector capacitor replacement, each volume, switch cleaning, pin jack polishing, internal inspection and cleaning, running test.)
Accessories: copy of the manual
Main specifications: 105W+105W (6Ω) 90W+90W (8Ω) phono MM/ MC switching W430 x H162 x D452 mm 18 kg
Maintained! The dust cover is hingeless. A classic record player that Technics is proud of. It is attractive for its simple design, stable operation, and outstanding durability. This model is recommended as an introductory model and as a secondary unit. There is a feeling of use (Daiki Goto)
Maintenance information: 2024.5.13 Maintained (by disassembling the upper and lower mechanism of the arm, wipe off the stuck grease and apply new grease and reassemble. There were no other operation or sound inspection abnormalities.)
Accessories: EP adapter
Main specifications: quartz lock direct drive, full manual type, 33/45 rotation, adjustable pitch control, W453 x H360 x D162 mm, 12 kg
※1 bottle only. The diaphragm has been replaced with a D8R2421. It is an 8 ohm specification. Maintained! The classic model for professional 1" screwdrivers. It is installed in many of the company's 43 series, etc., and it is a driver that is easy to balance with various woofers and tweeters. The exterior has dullness and small scratches. Serial 23890 (Yonejima Satoshi)
Maintenance information: 2024.5.25 Maintained (diaphragm installation adjustment, pad dampener, mounting screw rust replacement. Material terminal contact part cleaning, terminal dirt cleaning, insulation bushing replacement. Diaphragm dirt cleaning. (This is a genuine diaphragm, but it comes with D8R2421)
Accessories: No accessories
Main specifications: 1 inch driver, throat diameter: 25 mm, 8 ohms (3.8 ohms), 118 dB, frequency characteristics, 800 Hz to 20 kHz, crossover frequency: 500 Hz or more, 5.1 kg
*Currently sold. Bose's classic full range speaker. This model has a reputation for its well-organized and punchy sound quality. It can be used for a wide range of purposes, from subsystems to surround use. The exterior has a feeling of use such as dullness (Kobayashi Hitoshi)
Maintenance information: 2024.6.4 operation confirmed
Accessories: saran net
Main specifications: full range unit, 6Ω output, sound pressure level 88dB, magnetic-proof type, W270 x H168 x D180 mm, 4k g/unit, MS-2 size, W230 x H47 x D200 mm, 0.65 kg
※ It is inexpensive because it is in poor condition such as dirt and felt peeling. Set of 3 classic TAOC basses. Made of high-carbon cast iron with excellent vibration handling capabilities. It can be used for a wide range of speakers from large to medium, and accurately reproduces sound images. The exterior has rust and dirt due to aging, and deterioration in the bottom felt (Satoshi Yonejima)
Accessories: none
Main specifications: W100×H200×D300mm 9.2 kg
19-inch rack case, carpeted Compared to conventional rack cases, the CPC series uses a sturdy catch lock, corner bracket, and handle, and is spacious yet kept at a low price with a depth of 57.5 cm. It also works great with heavyweight power amplifiers and samplers! There is a feeling of use on the exterior such as dullness and small scratches (Asaine Tomoho)
Accessories: none
Main specifications: size W53.5 cm x H56 cm x D58 cm, weight approx. 23.9 kg (actual measurement)
19-inch rack case, carpeted Compared to conventional rack cases, the CPC series uses a sturdy catch lock, corner bracket, and handle, and is spacious yet kept at a low price with a depth of 57.5 cm. It also works great with heavyweight power amplifiers and samplers! There is a feeling of use on the exterior such as dullness and small scratches (Asaine Tomoho)
Accessories: none
Main specifications: size W53.5 cm x H56 cm x D58 cm, weight approx. 23.9 kg (actual measurement)
※It is inexpensive because it has a lot of feeling of use. A classic disc stabilizer. The moderate weight gives a sense of stability for playing records. The exterior has a feeling of use such as fading due to aging (Kanai Hidetsugu)
Accessories: none
Main specifications: diameter 80 mm height 35 mm dead weight approx. 600 g
Mount adapter compatible with 35mm diameter speaker stands. This adapter is used when mounting speakers that do not have a hole in the bottom (Tetsuji Oikawa)
Main specifications: load capacity approx. 30 kg, stand mount diameter: 35 mm, base thickness: approx. 8 mm